iPower Motor GM110-10 Combo Set

Description：

• The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers. This version of the controller is our new direction in the development of stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.

Features:

• Size of the board: 50×50 mm
• The distance between the mounting holes: 45 mm
• The diameter of the mounting holes: 3 mm
• Power supply voltage: 3S to 6S
• Maximum motor current: 1,5 A
• 5V output current to power external devices: up to 1 A

GM110-10 Gimbal Motor 

• The principle of the camera stabilization using brushless direct-drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
• Special designed for SLR aerial and Z axis DIY Parts

• Sealed Case to prevent contamination by dust and dirt.
• Hollow shaft for slipring
• Configuration: 36N42P ,prove more torque.

Specs:

• Model: GM110-10
• Motor Out Diameter: Ф110±0.05mm
• Motor Height: 26±0.2mm (Included with Encoder housing)
• Hollow Shaft(OD): Ф25-0.008/-0.012 mm
• Hollow Shaft(ID): Ф22+0.05/+0.1 mm
• Wire Length: 610±3mm
• Cable AWG: #24
• Motor Weight: 532±1g
• Wire plug: 2.5mm dupont connector
• No-load current: 20V
• No-load volts: 0.16±0.1 A
• No-load Rpm: 292~323 RPM
• Load current: 20V
• Load volts: 2A
• Load torque(g): 9000-15000
• Motor internal resistance: 4.16Ω±5%（Resistance varies with temperature）
• High voltage test: DC500V 1mA @2sec
• Rotor housing runout: ≤0.1mm
• Steering (axle extension): clockwise
• High-low temperature test:
• High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
• Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
• Maximum power: ≤80W
• Working current: 4-6S
• Working temperature: -20~60℃;10~90%RH

Package included: 

• 3 x GM110-10 Gimbal Motor
• 1 x Alexmos 32BIT BGC set without alum case
• 1 x Connecting cables set