Description
Description
- The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers.
- This version of the controller is our new direction in the development of the stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.
iPower Motor GM5208-12 Brushless Gimbal Motor
- The GM52 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras.
- This motor is designed for large-scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque.
- The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Specifications
- Model: GM5208
- Motor Out Diameter: Ф63±0.05mm
- Motor Height: 22.7±0.2mm
- Hollow Shaft(OD): Ф15-0.008/-0.012 mm
- Hollow Shaft(ID): Ф12+0.05/0 mm
- Wire Length: 610±3mm
- Cable AWG: #24
- Motor Weight: 195±0.5g
- Wire plug: 2.5mm dupont connector
- No-load current: 0.09±0.1 A
- No-load volts: 20V
- No-load Rpm: 456~504 RPM
- Load current: 1A
- Load volts: 20V
- Load torque(g): 1800-2500
- Motor internal resistance: 15.2Ω±5%（Resistance varies with temperature）
- High voltage test: DC500V 10mA @1sec
- Rotor housing runout: ≤0.1mm
- Steering (axle extension): clockwise
- High-low temperature test:
- High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Maximum power: ≤40W
- Working current: 3-5S
- Working temperature: -20~60℃;10~90%RH
Packing List
- 3 x GM5208-12 Gimbal Motor
- 1 x Alexmos 32BIT BGC set without alum case
- 1 x Connecting cables set