Description
Description
- The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Features
- Sealed Case to prevent contamination by dust and dirt.
- Hollow shaft for slipring
- Configuration:24N28P,provide more torque.
Specifications
- Model: GM110-8
- Motor Out Diameter: Ф110±0.05mm
- Motor Height: 33.9±0.2mm (Included with Encoder housing)
- Hollow Shaft(OD): N/A
- Hollow Shaft(ID): N/A
- Wire Length: 610±3mm
- Cable AWG: #24
- Motor Weight: 610±3g
- Wire plug: 2.5mm dupont connector
- No-load current: 0.09±0.1 A
- No-load volts: 20V
- No-load Rpm: 125~139 RPM
- Load current: 2A
- Load volts: 20V
- Load torque(g): 8000-12000
- Motor internal resistance: 20.19Ω±5%（Resistance varies with temperature）
- High voltage test: DC500V 1mA @2sec
- Rotor housing runout: ≤0.1mm
- Steering (axle extension): clockwise
- High-low temperature test:
- High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Maximum power: ≤60W
- Working current: 4-6S
- Working temperature: -20~60℃;10~90%RH
Packing List
- 1 x GM110-8 with AS5048A Encoder