Description
Description
- The principle of the camera stabilization using brushless direct-drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
- Special designed for SLR aerial and Z axis DIY Parts
Features
- Sealed Case to prevent contamination by dust and dirt.
- Hollow shaft for slipring
- Configuration: 36N42P ,prove more torque.
Specifications
- Model: GM110-10
- Motor Out Diameter: Ф110±0.05mm
- Motor Height: 26±0.2mm (Included with Encoder housing)
- Hollow Shaft(OD): Ф25-0.008/-0.012 mm
- Hollow Shaft(ID): Ф22+0.05/+0.1 mm
- Wire Length: 610±3mm
- Cable AWG: #24
- Motor Weight: 532±1g
- Wire plug: 2.5mm dupont connector
- No-load current: 0.16±0.1 A
- No-load volts: 20 V
- No-load Rpm: 292~323 RPM
- Load current: 2 A
- Load volts: 20 V
- Load torque(g): 9000-15000
- Motor internal resistance: 4.16Ω±5%（Resistance varies with temperature）
- High voltage test: DC500V 1mA @2sec
- Rotor housing runout: ≤0.1mm
- Steering (axle extension): clockwise
- High-low temperature test:
- High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Maximum power: ≤80W
- Working current: 4-6S
- Working temperature: -20~60℃;10~90%RH
Packing List
- 1 x GM110-10 brushless gimbal motor