Description
Features
- Improved circuit design, better components and lower electrical noise!
- DJI HD VTX Connector (Plug-and-Play / No soldering required)
- FC indicator LEDs for visual debugging
- Support Betaflight, INAV, Ardupilot firmware
FC Specifications
- MCU: STM32F745
- Gyro: ICM42688
- Barometer: DPS310
- OSD Chip: AT7456E
- Flash: 32MB (Blackbox flash)
- UARTS: 6
- Smartaudio / IRC Tramp VTX protocol supported
- LED controller: Yes
- Beeper pad: Yes
- Firmware target: IFLIGHT_BLITZ_F7_AIO
- Mount pattern: 30.5*30.5mm
- Dimensions: 36.5*35 mm
- Weight: 7.8g
- BEC: 5V 2.5A / 9V 2A
Wiring Suggestion
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemet
ESC Specifications
- Mounting Holes: 30.5*30.5mm/Φ4mm
- Weight: 15.3g
- Supports 2-6S lipo input
- MCU: G071
- Constant: 55 Amps
- Burst: 65 Amps
- Current sensor: Yes
- BEC: No
- Current rate: 200
- Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
- Target: IFLIGHT_BLITZ_G3 32.9
Packing List
- 1 x BLITZ F745 V1.2 Flight Controller
- 1 x BLITZ E55S 4-IN-1 2-6S ESC
- 1 x silicon grommets
- 1 x wire harness for F7 Flight controller