Description
Description
- The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers.
- This version of the controller is our new direction in the development of the stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.
Specifications
- Model: GM2804
- Motor Out Diameter: Ф35±0.05mm
- Motor Height: 15±0.2mm
- Hollow Shaft(OD): Ф8-0.008/-0.012 mm
- Hollow Shaft(ID): Ф6.5+0.05/0 mm
- Wire Length: 60±3mm
- Cable AWG: #24
- Motor Weight: 42.3±0.2g
- Wire plug: PH3P connector
- No-load current: 0.09±0.05 A
- No-load volts: 10 V
- No-load Rpm: 1602~1771 RPM
- Load current: 0.8A
- Load volts: 10V
- Load torque(g): 250-350
- Motor internal resistance: 9Ω±5%（Resistance varies with temperature）
- High voltage test: DC500V 1mA @2sec
- Rotor housing runout: ≤0.1mm
- Steering (axle extension): clockwise
- High-low temperature test:
- High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
- Maximum power: ≤25W
- Working current: 2-3S
- Working temperature: -20~60℃;10~90%RH
Packing List
- 3 x GM2804-100T Gimbal Motor
- 1 x Alexmos 32BIT BGC set without alum case
- 1 x Connecting cables set